Kingston PC3-12800 1600MHz 64GB ValueRAM CL11 (4x16GB) DDR3

905.90 € 905.90 €
Descrição "Kingston PC3-12800 1600MHz 64GB ValueRAM CL11 (4x16GB) DDR3"


ValueRAM's KVR16R11D4K4/64 is a kit of four 2G x 72-bit

(16GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM),

registered w/parity, 2Rx4 ECC memory modules, based on

thirty-six 1G x 4-bit FBGA components per module. Total kit

capacity is 64GB. The SPDs are programmed to JEDEC

standard latency DDR3-1600 timing of 11-11-11 at 1.5V. Each

240-pin DIMM uses gold contact fingers. The electrical and

mechanical specifications are as follows:

CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 6.681 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0
C to 85
Storage Temperature -55
C to +100

JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
On-DIMM thermal sensor (Grade B)
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component

Podemos sugerir