1255

Kingston PC3-12800 1600MHz 2GB ValueRAM CL11 SO-DIMM (1x2GB) DDR3

KVR16S11S6/2
24.95 € 24.95 €
Descrição "Kingston PC3-12800 1600MHz 2GB ValueRAM CL11 SO-DIMM (1x2GB) DDR3"

DESCRIPTION
This document describes ValueRAM's 256M x 64-bit (2GB)
DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx16,
memory module, based on four 256M x 16-bit FBGA compo-
nents. The SPD is programmed to JEDEC standard latency
DDR3-1600 timing of 11-11-11 at 1.5V. This 204-pin SODIMM
uses gold contact fingers. The electrical and mechanical specifications are as follows

SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 1.170 W*
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C
*Power will vary depending on the SDRAM used

FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6, 5
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), single sided component

Podemos sugerir