2204

Kingston PC3-12800 1600MHz 16GB ValueRAM CL11 (2x8GB) DDR3

KVR16N11K2/16
178.70 € 178.70 €
Descrição "Kingston PC3-12800 1600MHz 16GB ValueRAM CL11 (2x8GB) DDR3"

DESCRIPTION

ValueRAM's KVR16N11K2/16 is a kit of two 1G x 64-bit (8GB)

DDR3-1600 CL11 SDRAM (Synchronous DRAM) 2Rx8, memory

modules, based on sixteen 512M x 8-bit FBGA components per

module. Total kit capacity is 16GB. The SPDs are programmed

to JEDEC standard latency DDR3-1600 timing of 11-11-11 at

1.5V. Each 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows


SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Maximum Operating Power 2.580 W* (per module)
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C

*Power will vary depending on the SDRAM used


FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
Asynchronous Reset
PCB : Height 1.180” (30.00mm), double sided component

Podemos sugerir