1299

Kingston PC3-10600 1333MHz 4GB ValueRAM SRX8 CL9 (1x4GB) DDR3

KVR13N9S8/4
32.85 € 32.85 €
Descrição "Kingston PC3-10600 1333MHz 4GB ValueRAM SRX8 CL9 (1x4GB) DDR3"

DESCRIPTION

This document describes ValueRAM's 512M x 64-bit (4GB)

DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8 memory

module, based on eight 512M x 8-bit DDR3-1333 FBGA compo-

nents. The SPD is programmed to JEDEC standard latency

DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses

gold contact fingers. The electrical and mechanical specifications are as follows


SPECIFICATIONS
CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 49.5ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 36ns (min.)
Maximum Operating Power 2.100 W*
UL Rating 94 V - 0
Operating Temperature 0
o
C to 85
o
C
Storage Temperature -55
o
C to +100
o
C


FEATURES
JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE
< 95°C
Asynchronous Reset
PCB: Height 0.740” (18.75mm), single sided component

Podemos sugerir